Murco MGS Spécifications télécharger pdf (Page 8)

MGS Installation and Operation Manual

8 1000-0085 Rev 0

Section 2. Installation and Wiring

WARNING: Explosion hazard! Do not mount the MGS in an area

that may contain flammable liquids, vapors, or aerosols. Operation

of any electrical equipment in such an environment constitutes a

safety hazard.

CAUTION: The MGS contains sensitive electronic components

that can be easily damaged. Do not touch nor disturb any of these

components.

NOTE: The mounting location of the monitor should allow it to be

easily accessible for visual monitoring and servicing.

NOTE: The monitor must be connected by a marked, suitably

located and easily reached switch or circuit-breaker as means of

disconnection.

NOTE: Connect monitor power and signaling terminals using

wiring that complies with local electrical codes or regulations for the

intended application.

NOTE: This instrument can be equipped with a semiconductor

sensor for the detection of refrigerant, combustible and VOC gases.

Semiconductor sensors are not gas specific and respond to a variety

of other gases including propane exhaust, cleaners, and solvents.

Changes in temperature and humidity may also affect the sensor’s

performance.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 30 31

Pas de commentaire

Murco MGS Spécifications Page 8